AF2 Home · Engineering Information · Telescope Operator · Duty Engineer · AF2 Experts · Links

Autofib 2 SETSERVO Command

This is an Engineering Interface Engineering Commands and is to be issued at the engineering interface.

SETSERVO Command
 

Format: SETSERVO axis speed accl

axis = select axis
speed = select speed (microns/s)
accl = select acceleration (microns/s/s)
Description:  This command changes the current servo loop parameters for the axis specified, the other two parameters required are the new speed in microns/s and the new acceleration in microns/s/s. There is an upper limit built into the micro code that prevents speeds and acceleration exceeding the maximum tested values being used.
Example: Engineering command > SETSERVO x 20 5

For further information refer to the `AF2 Control System Software Manual'.

Links to other Engineering Interface Engineering Commands
 
 
backillum health local parkrobot  ringallfibre tell_transform tolerance
centroid  help logging  power ringfibre  tellfib  viewfibre 
diagnostics iterations  monitor quadrant  rlog tellmimic viewfiducial 
disablefibre  init  motors quit setmimic  tellpos viewobject 
disableguide  killfibre  movefibre  random setservo  tellservo viewsky 
enablefibre  killguide  moveprobe  recover  setup tellsource  wake
enableguide lasterror moverobot  reference  setvideo tellstat whichfibre
extended lastmove netreset  remote sleep telltemp zmove
extract  lights  offsetfibre  resetcurrfib static tellvideo   
gripper  loadfibre  offsetrobot resetlostflag  stopsetup  tlog  
hardreset loadmodule  parkfibre  restricted tell_log tmove   

Created by Stephen Goodsell
sjg@ing.iac.es
Last updated 9/01