AF2 Home · Engineering Information · Telescope Operator · Duty Engineer · AF2 Experts · Links

Autofib 2 RECOVER Command

This is an Engineering Interface Engineering Commands and is to be issued at the engineering interface.

RECOVER Command
 

Format: RECOVER  (no parameters)
Description:  This command should be used directly after a pickup or putdown failure in order to recover and check the location of the last fibre that was moved. If a fibre is recovered successfully the internal fiberror flag is reset allowing further fibres to be moved.
Example: Engineering command > recover

For further information refer to the `AF2 Control System Software Manual'.

Links to other Engineering Interface Engineering Commands
 
 
backillum health local parkrobot  ringallfibre tell_transform tolerance
centroid  help logging  power ringfibre  tellfib  viewfibre 
diagnostics iterations  monitor quadrant  rlog tellmimic viewfiducial 
disablefibre  init  motors quit setmimic  tellpos viewobject 
disableguide  killfibre  movefibre  random setservo  tellservo viewsky 
enablefibre  killguide  moveprobe  recover  setup tellsource  wake
enableguide lasterror moverobot  reference  setvideo tellstat whichfibre
extended lastmove netreset  remote sleep telltemp zmove
extract  lights  offsetfibre  resetcurrfib static tellvideo   
gripper  loadfibre  offsetrobot resetlostflag  stopsetup  tlog  
hardreset loadmodule  parkfibre  restricted tell_log tmove   

Created by Stephen Goodsell
sjg@ing.iac.es
Last updated 9/01