Single Chip EEV4280 SDSU Wiring
These cameras all have two working outputs. We only ever use one amplifier at a time.
The internal and external cabling and board configuration of the SDSU controller is the same for all the single chip EEV (now called Marconi) cameras.
Information on SDSU internal cabling for all Single EEV cameras (drawing), (table), (PDF)
Photos of the SDSU Boards used for Single EEV Cameras
Information on EEV4280 External Cable (Table), (Drawing), (PDF) (also information on the internal cryostat wiring)
EEV camera set-up voltages are shown below for each camera. Useful for controller troubleshooting.
