Mounting the CD-ROM and Running the Installer

Mounting the CD-ROM and Running the Installer

Insert the TclPro CD-ROM into your CD-ROM drive. To access the CD-ROM on HP-UX and Linux, you must mount the drive to a directory on your filesystem. Use a command from the table below to mount the CD-ROM.

Table 3 Mounting the CD-ROM
Operating System
Command to Mount CD-ROM

HP-UX
mount -o cdcase /dev/dsk/c1t2d0 /cdrom
Ask your system administrator to verify the CD-ROM device.

Red Hat Linux
mount -o exec,mode=0555 /mnt/cdrom

Suse Linux
mount -o exec,mode=0555 /mnt/cdrom

Caldera Linux
mount -o exec,mode=0555 /dev/scd0 /mnt/cdrom

Run the TclPro installation program using the command shown in the table below. By default, the installer displays a graphical user interface. To run a text-only installation, include the T argument when running the installer.

Table 4 Commands to Start the Installer
Operating System
Command to Start Installer

HP-UX
/cdrom/setup.sh

Irix
/CDROM/setup.sh

Red Hat Linux
/mnt/cdrom/setup.sh

Suse Linux
/mnt/cdrom/setup.sh

Caldera Linux
/mnt/cdrom/SETUP.SH or /mnt/cdrom/setup.sh

Solaris
/cdrom/tclpro_1_4/setup.sh

***Table 3 Mounting the CD-ROM***
Operating System	Command to Mount CD-ROM
HP-UX	mount -o cdcase /dev/dsk/c1t2d0 /cdrom Ask your system administrator to verify the CD-ROM device.
Red Hat Linux	mount -o exec,mode=0555 /mnt/cdrom
Suse Linux	mount -o exec,mode=0555 /mnt/cdrom
Caldera Linux	mount -o exec,mode=0555 /dev/scd0 /mnt/cdrom

***Table 4 Commands to Start the Installer***
Operating System	Command to Start Installer
HP-UX	/cdrom/setup.sh
Irix	/CDROM/setup.sh
Red Hat Linux	/mnt/cdrom/setup.sh
Suse Linux	/mnt/cdrom/setup.sh
Caldera Linux	/mnt/cdrom/SETUP.SH or /mnt/cdrom/setup.sh
Solaris	/cdrom/tclpro_1_4/setup.sh

http://www.ajubasolutions.com
Voice: (650) 210-0100
Fax: (650) 210-0101
support@ajubasolutions.com