Startup and Exit Preferences

---

The Startup & Exit Preference tab is shown in Figure 5.

Figure 5 The Startup & Exit Preference Tab

The Startup preference controls TclPro Debugger's behavior when you start the debugger:

• Reload the Previous Project on Startup: TclPro Debugger reloads the project you had open when you last exited TclPro Debugger

The Exit preferences control TclPro Debugger's behavior when you quit the debugger:

• On exit, ask if the application should be killed: TclPro Debugger prompts you to kill the application when you exit the debugger
• On exit, always kill the application: TclPro Debugger always kills the application when you exit the debugger
• On exit, always leave the application running: TclPro Debugger leaves the application running when you exit the debugger
• Warn Before Killing the Application: TclPro Debugger always prompts you when you are about to perform an action that would kill the application

After changing the Startup & Exit tab settings, click one of the following buttons:

• OK to save your choices and close the Preferences window
• Cancel to cancel your choices and close the Preferences window
• Apply to apply your choices and keep the Preferences window open.

http://www.ajubasolutions.com Voice: (650) 210-0100 Fax: (650) 210-0101 support@ajubasolutions.com