Appearance Preferences
The Appearance Preference tab is shown in Figure 3.
Figure 3 The Appearance Preference Tab
You can choose the following Appearance preferences:
- Type-The name of the font used to display code, stack frames, variables, etc.
- Size-The size of the font used to display code, stack frames, variables, etc.
- TclPro Debugger attempts to optimize your font and size preferences. If you enter a font that is unavailable, TclPro Debugger finds a similar font on your computer and substitutes it. Ajuba Solutions recommends that you only use fixed-width fonts.
- Small font sizes can cause misalignment of the symbols in the Code Bar and their corresponding lines of code. If you experience problems, increase the font size.
- Highlight-The color TclPro Debugger uses when it stops to highlight the next command it will execute
- Highlight On Error-The color TclPro Debugger uses to highlight a command in which it finds an error
- Highlight On Result-The color TclPro Debugger uses to highlight code it just executed after a Step To Result
After changing the Appearance tab settings, click one of the following buttons:
http://www.ajubasolutions.com Voice: (650) 210-0100 Fax: (650) 210-0101 support@ajubasolutions.com |