Red+ SDSU Wiring
These cameras all have two working outputs. We only ever use one amplifier at a time.
The internal and external cabling and board configuration of the SDSU controller is the same as for all the single chip Red+, EEV & Marconi cameras.
Information on SDSU internal cabling for the Red+ camera  (drawing), (PDF) ( identical to the EEV)

Photos of the SDSU Boards used for Red+ Camera (identical to single EEV & Marconi boards)

Information on Red+ External Cable (Table), (Drawing), (PDF) (this external wiring is identical to the EEV)
Red+ camera set-up voltages are shown below for each camera. Useful for controller troubleshooting. 
Red+ Voltages (table)
Red+2 Voltages (table)
 
  Manufacturers data sheet
Manufacturers web site 
Detector Performance
 
Detector Group Astronomy Pages

ING Home

Feedback