Auxcam SDSU Wiring
This camera has two working outputs. We only ever use one amplifier at a time.
The internal and external cabling and board configuration of the SDSU controller is the same as for all the single chip AUXCAM, Red+, EEV & Marconi cameras.
Information on SDSU internal cabling for the AUXCAM camera  (drawing), (PDF) ( identical to the EEV)

Photos of the SDSU Boards used for AUXCAM Camera (identical to single EEV, Red+ & Marconi boards)

Information on AUXCAM External Cable (Table), (Drawing), (PDF) (this external wiring is identical to the EEV)
Auxcam camera set-up voltages are shown below. Useful for controller troubleshooting. 
Auxcam Voltages (table)
 
  Manufacturers data sheet
Manufacturers web site 
Detector Performance
 
Detector Group Astronomy Pages

ING Home

Feedback