Which SPARCs are available to visitors?

Vistors need to acquire an account before they can log on. If visitors are observers they can use these accounts during their observing run only.

intguest

jktguest

whtguest

If visiting observers require access for a few days either before or after their run then they should apply for a guest account. All other visitors who need access to the ING's computers should also request an account.

Sparcs for use by observers

Observers can tell which sparcs are intended for them because the login screen has the icon below (applies solaris 9 hosts only). If using the account for purposes other that running the observing system always use the Data Reduction (DR) sparc. These sparcs have hostnames which change as more modern sparcs replace older ones but three aliases are always correct.

	Only XXT Observer ...	Locations
	intdr.roque.ing.iac.es jktdr.roque.ing.iac.es (Note there is no longer a whtdr use linux PC ____ instead)	INT control room JKT control room (N/A)

Sparcs for use by other visitors

Other visitors and staff can tell which sparcs are intended for them because the login screen has the icon below.

	All ING ...	Locations
	cs1.ing.iac.es cs2.ing.iac.es lpss26.ing.iac.es	WHT terminal area adjacent to WHT control room WHT control room SLO

Sparcs not available for use

These include machines which have a dedicated purpose or used for administration purposes. These may have any on the icons below. >

	Only CFG ...
	lpss9 indus jineta vela corvus	Reserved for the provision of services

	Only Personal Accounts ...
	scorpio	Only real-person named accounts are valid on sparcs which are accessible from outside ING

	Only DAS ...
	lpss14 cygnus draco

This page is available on-line as
http://www.ing.iac.es/~cfg/pub_notes/visisparc.htm