
AF2
Readiness check document
Please report any errors or other
suggestions to
Rene J. Pit
Section 1 : |
Preparation (Day Before) |
|
Check that
GHRIL is prepared:
- Internal inspection of WYFFOS.
- Check engineering schedule. Set-up WYFFOS for
correct mode (reflection or echelle).
- Check WYFFOS CCD is prepared and cold, pump if required.
- Ensure clear access is available for WYFFOS grating.
- Check WYFFOS is operational and all maintenance etc is
complete.
- Check WYFFOS Calibration Unit is operational and all
maintenance etc is complete.
- Make sure that both AF2PC's are switched on and
that CFG has carried out a sanity check on both PC's
- Make sure that the Interconnect module and power
amplifier rack are fitted.
- Connect the AF2 cable loom from prime to the Interconnect
module and AF2 power amplifier rack.
- Connect the AF2 power amplifier rack to the Interconnect
module.
- Connect Gripper TV
BNC to Linux Power PC connector on video
in cable.
- Connect the video out BNC to Gripper
monitor BNC that goes to No.82 on the patch panel
- Connect portserver port 8 to Prime port 2 on the
patch panel.
Check that the Prime
Focus Unit is prepared:
- Check that the Prime Focus Unit is in its
handling trolley and ensure that the prime focus instrument platform
PFIP has been removed
- Ensure the lifting frame is correctly balanced for lifting
the Prime Focus unit.
Check AF2
Check that the Fibre
Module is prepared:
- Find the aluminium box containing the fibre module in the
WHT drum ground floor and move the box to the aluminising area.
- Find a table and a magnifying lamp. The lamp may be
borrowed from the detector lab.
- Open the box and undo the 4 M10 bolts.
- Fix the the fibre outlet box onto its aluminium store
yoke.
- With at least 2 more persons lift the fibre module onto
the
table, with the fibres upwards.
- Fix the magnifying lamp onto the table.
- Check each fibre on:
- Damaged prism
- Twisted prism
- Loose magnet.
- Displaced magnet holder or shark vin
- Carefully lift each fibre of the surface to test the
magnets strenght.
- Then put all the fibres into a circle on the edge of the
blank metal surface.
- Clean the blank metal surface carefully with propanol.
- Get a can of WD40 (or something similar), spray a bit on a
cloth and apply it very lightly to the blank metal surface. This is to
prevent the surface from oxidizing.
- When finished put the unit back into its alu. box.
Check that the equipment
is ready for lifting:
- Remove AF2 Robot from its handling trolley and put it in
its lifting frame.
- Prepare AF2 Robot and the small fibre module for lifting up
to the dome area in the morning.
Check Ancillary
equipment:
- Check you have a working autoguider AG2 head and
controller.
- Check you have a working TV camera AG1 and controller.
- Locate swans neck and CCD controller racks.
- Check that all cables are accounted for.
Check lifting equipment:
- Two one tonne strops and shackles required.
- Looking down from AP3. Place the following trolleys on the
ground floor to the right of the telescope. Secondary Lifting Trolley
and frame, Prime Focus Unit, AF2 robot in its handling trolley.
Check control room is
prepared:
- Connect AF2 video monitor to GHRIL patch panel: video=82.
Last updated 21 August 2009 by RJP