Previous: Initialisation, status and cancel commands
Up: Initialisation, status and cancel commands
Next: UES_UPDATE
Previous Page: Initialisation, status and cancel commands
Next Page: UES_UPDATE
Initialise specified mechanism
Format: UES_INIT <parameter>
Units: None
Parameter: Any individual mechanism name, or ALL, NAG or UES
Examples : UES_INIT USLITWIDTH
Comments: If ALL is specified, all mechanisms are initialised. If NAG is specified, only A&G mechanisms are initialised, and if UES is specified, only spectrograph mechanisms are initialised. Note that initialisation of all UES mechanisms is slow.