Previous: QWHEEL - Lists current wheels and range of available wheels
Up: FILTERS FOR THE CCD CAMERA
Next: EDITTABLE - Edits the filter correspondence table
Previous Page: QWHEEL - Lists current wheels and range of available wheels
Next Page: EDITTABLE - Edits the filter correspondence table
This allows the filter parameters in the current WHEEL file to be edited.
Adam:> EDITWHEEL
and follow the prompts. Starting with the filter in position 1 you will be asked if you wish to change any of the parameters (Magzero, Focus Offset, Name, Filter Thickness or Type). You can stop after any of these by typing END. You will then be prompted for any changes to the filter in position 2 and so on. To exit from the program at any time type STOP. To edit a different wheel use the WHEEL command to select it first.