Previous: RUNSTAT(US)/TIM(E) - Run control (2)
Up: CCD CONTROL COMMANDS
Next: CCDINIT/RESET(CCD) - Complete and partial re-initialisation
Previous Page: RUNSTAT(US)/TIM(E) - Run control (2)
Next Page: CCDINIT/RESET(CCD) - Complete and partial re-initialisation
Read and display telemetry values, indicating which ones are out of range.
Parameters
The default is to output only those values that are out of range. If called with QUIET=F, all values are listed. If called with HEADER=T, a heading is printed.
Examples
Adam:> TELE QUIET=F (List all values)
N.B. TELE cannot be issued whilst a run is ACTIVE