Previous: All observations
Up: Change checklist
Previous Page: All observations
Next Page: Installation of Cameras

Fabry-Perot mode only

  1. A nitrogen flush to the etalon cavity is required, with the flow rate independently controllable via a flow meter.

  2. The CS100 and the switchbox are mounted on the side of TAURUS itself. There are 6 cables between the CS100 and the switchbox, plus a mains supply for each.

  3. If the IPCS is being used, then in order to implement the handshake between TAURUS and IPCS, a connection is required from the TAURUS 4MS socket J110 to the socket on the IPCS CCD controller labelled 'TAURUS SKCC'

Thu Apr 7 00:29:52 BST 1994