Previous: CS100_GAIN
Up: Reference section
Next: CS100_LOC
Previous Page: CS100_GAIN
Next Page: CS100_LOC

CS100_INT

Enable or disable integration on CS100 servo--loop

Format: CS100_INT <parameter>

Units: none

Range: <parameter> = ON or OFF

Defaults: Defaults to OFF on power--up

Examples : CS100_INT ON

Comments: Issuing CS100_INT will only result in a change of state of the CS100 once external control has been enabled (command CS100_EXT). The CS100 is normally used with integration off.


Thu Apr 7 00:29:52 BST 1994