Previous: CS100_TICO
Up: Reference section
Next: CS100_YOFF
Previous Page: CS100_TICO
Next Page: CS100_YOFF
Applies an offset to the X channel of the CS100 servo--loop
Format: CS100_XOFF <offset>
Units: none
Range: --2048 < <offset> < 2047
Defaults: Defaults to 0 on power--up
Examples : CS100_XOFF 100
Comments: Issuing CS100_XOFF will only result in a change of state of the CS100 once external control has been enabled (command CS100_EXT). The etalon will only change state if the CS100 has been switched to the etalon (command ETALON_VOLTAGE) and the servo loop closed (command CS100_CLOSE).