next up previous contents
Next: ICS/DAS startup Up: TCS startup Previous: Adding your own source

Closing and restarting the TCS

To stop the TCS type
         USER> park zen
and switch to engineering mode. Cancel the TCS alarm
         USER> acknowledge
         USER> tcsexit
to stop the TCS.

If the TCS User Interface hangs:

switch to engineering mode,
start another TELNET session to lpas1,
login as user JKT_LOGIN,
and choose the STOP option.
If the telescope was not at zenith when stopping the TCS, move it back to (near) zenith with the console buttons. Then restart as above, if you wish. Don't forget to ZEROSET and CALIBRATE.