Previous: WHE(EL) - Select a filter wheel or input parameters for a new one
Up: FILTERS
Next: QWHE(EL) - List the current wheel and the range of available wheels
Previous Page: WHE(EL) - Select a filter wheel or input parameters for a new one
Next Page: QWHE(EL) - List the current wheel and the range of available wheels

EDITWHEEL - Edits the current wheel parameters

This allows the filter parameters in the current WHEEL file to be edited

Example

Adam:> EDITWHEEL

and follow the prompts.

Starting with the filter in position 1, you will be asked if you wish to change any of the parameters (Magzero, Focus Offset, Name, Filter Thickness or Type). You can stop after any of these by typing END.

You will then be prompted for any changes to the filter in position 2 and so on.

To exit from the program at any time, type STOP.

To edit a different wheel, use the WHEEL command to select it first.