Previous: TEL(E) - System Telemetry
Up: CCD CONTROL COMMANDS
Next: OP(EN)/CLO(SE) - Shutter control
Previous Page: TEL(E) - System Telemetry
Next Page: OP(EN)/CLO(SE) - Shutter control

CCDINIT/RESET(CCD) - Re-initialisation

CCDINIT performs a complete re-initialisation of the CCD system. This can result in messages of warning of variables being re-declared but should always be safe. RESETCCD merely re-initialises the CCD controller. This is necessary if there has been an error or timeout on READ, CLEAR or FLASH.

Parameters

None

Examples

Adam:> CCDINIT

Adam:> RESETCCD