Previous: RUNSTAT(US)/TIM(E)- How long to go?
Up: CCD CONTROL COMMANDS
Next: CCDINIT/RESET(CCD) - Re-initialisation
Previous Page: RUNSTAT(US)/TIM(E)- How long to go?
Next Page: CCDINIT/RESET(CCD) - Re-initialisation

TEL(E) - System Telemetry

Read and display telemetry values, indicating which ones are out of range.

Parameters

The default is to output only those values that are out of range. If called with QUIET=F, all values are listed. If called with HEADER=T, a heading is printed.

Examples

Adam:> TELE QUIET=F (List all values)

Do not run TELE whilst a run is ACTIVE