Previous: CALR(UN) - Perform a calibration run
Up: CCD CONTROL COMMANDS
Next: MULTBIAS - Takes and averages bias frames
Previous Page: CALR(UN) - Perform a calibration run
Next Page: MULTBIAS - Takes and averages bias frames

FLATF(IELD) - Performs a flat field run

Performs a flat field run, writing the image into a new file. Same as RUN, except that the observation type for flat field is stored in the observation packet.

Parameters

Exposure time (in seconds)

Object name

Example

Adam:> FLATFIELD 10 ``FLAT I FILTER''