Previous: MULTRUN - Perform several exposures each on a seperate frame
Up: CCD CONTROL COMMANDS
Next: CALR(UN) - Perform a calibration run
Previous Page: MULTRUN - Perform several exposures each on a seperate frame
Next Page: CALR(UN) - Perform a calibration run
Stops a series of runs started with MULTRUN. This procedure should always be used to abort a MULTRUN. Do not use BREAK and SEND CON: as this will not stop some of the background streams used by MULTRUN.
When this command is issued, the current run will be aborted, though the runs before this will all be saved on the dump device.