Mire al final de la lista hasta encontran FX16:. Si esta OFF, teclea:
MA FX16:,ON,,CD=ALL
y espere para el mensaje one line response, entonces teclee:
GO JKT
y espere el mensaje LOADJKT: END OF TASK 0. Si dice FX16:SYS teclee:
GO JKT y espere un mensaje, ya sea LOADJKT:END OF TASK 0 o CONTROL SYSTEM IS ALREADY RUNNING.
HA/S xx <CR> (arcsec/sec)
HA/G xx <CR> (arcsec/sec)
HA/I xx <CR> (arcsec)
xx son valores que usted pone. Los valores de startup (puesta en funcionamiento) son 50, 3 y 10 respectivamente. Active el control manual presionando los botones SET/GUIDE/INCREMENT sucesivamente (en el centro, parte mas inferior).