|
|||||||||||||||
Red+
SDSU Wiring |
|||||||||||||||
|
|||||||||||||||
These cameras all have two working outputs. We only ever use one amplifier at a time. | |||||||||||||||
The internal and external cabling and board configuration of the SDSU controller is the same as for all the single chip Red+, EEV & Marconi cameras. | |||||||||||||||
Information
on SDSU internal cabling for the Red+ camera (drawing),
(PDF) ( identical to the EEV)
Photos of the SDSU Boards used for Red+ Camera (identical to single EEV & Marconi boards) Information on Red+ External Cable (Table), (Drawing), (PDF) (this external wiring is identical to the EEV) |
|||||||||||||||
Red+ camera set-up voltages are shown below for each camera. Useful for controller troubleshooting. | |||||||||||||||
|
|||||||||||||||
Red+2 Voltages (table) |
|||||||||||||||
|
|
|
|||||||||||||
|
|||||||||||||||
|