|
|||||||||||||||
Auxcam SDSU Wiring
|
|||||||||||||||
|
|||||||||||||||
This camera has two working outputs. We only ever use one amplifier at a time. | |||||||||||||||
The internal and external cabling and board configuration of the SDSU controller is the same as for all the single chip AUXCAM, Red+, EEV & Marconi cameras. | |||||||||||||||
Information
on SDSU internal cabling for the AUXCAM camera (drawing),
(PDF) ( identical to the EEV)
Photos of the SDSU Boards used for AUXCAM Camera (identical to single EEV, Red+ & Marconi boards) Information on AUXCAM External Cable (Table), (Drawing), (PDF) (this external wiring is identical to the EEV) |
|||||||||||||||
Auxcam camera set-up voltages are shown below. Useful for controller troubleshooting. | |||||||||||||||
|
|||||||||||||||
|
|
|
|||||||||||||
|
|||||||||||||||
|