Autofib 2 OFFSETFIBRE Command

This is an Engineering Interface Engineering Commands and is to be issued at the engineering interface.

OFFSETFIBRE Command
 

Format: OFFSETFIBRE n dx dy

n = Fibre number
dx = offset increment along the x axis (microns)
dy = offset increment along the y axis (microns)
Description:  Offset fibre n by dx and dy microns.  The software checks that there will not be a collisions and moves the fibre.
Example: Engineering command > offsetfibre 103 20250 1000

For further information refer to the `AF2 Control System Software Manual'.

Links to other Engineering Interface Engineering Commands