Autofib 2 Fault - `afsetup' Fails Continuously (TO)

Description

If the ICL command `afsetup' fails then you should try and use the following procedure.

Try

If ICL has hung (not responding to any commands, try Ctrl Z, this will result in the prompt returning.

  1. Type 'kill af2_setup' - kills the af2_setup task
  2. Type 'kill af2' - kills the af2 task (this will probably be unnecessary)
  3. Type 'af2_load' - loads all af2 tasks
  4. Type 'af2_begin' - restarts all the af2 tasks
If this doesn't work then try the General Recovery Procedure.  If you have already tried that either contact the Duty Engineer or the appriopriate AF2 Expert.