|
|||||||||||||||
Marconi 42-90 SDSU Wiring
|
|||||||||||||||
|
|||||||||||||||
These cameras all have two working outputs. We only ever use one amplifier at a time. | |||||||||||||||
The internal and external cabling and board configuration of the SDSU controller is the same for all the single chip Marconi cameras. | |||||||||||||||
Information
on SDSU internal cabling for all Marconi cameras (table)
Photos of the SDSU Boards used for Marconi Cameras (identical to single EEV boards) Information on Marconi 4290 External Cable (Table), (Drawing), (PDF) (this external wiring is identical to the EEV) |
|||||||||||||||
Marconi camera set-up voltages are shown below for each camera. Useful for controller troubleshooting. | |||||||||||||||
|
|||||||||||||||
Photo of the inside of an Marconi camera | |||||||||||||||
|
|
|
|||||||||||||
|
|||||||||||||||
|