Running Code with TclPro Debugger
Click the Run button to run your code with TclPro Debugger, as shown in Figure 2. When the application stops, TclPro Debugger indicates the line of code that it is processing with an arrow and highlights the portion of the line that it is about to execute.
Once the application is running, it stops at these events:
- At breakpoints. For information about breakpoints, see "Using Breakpoints".
- If an error is detected, TclPro Debugger stops on the line of code that generated the error, and the code that caused the error is highlighted. See "Error Handling".
- If you click the Run to Cursor icon in the tool bar, the application runs to the line where you placed your cursor.
http://www.ajubasolutions.com Voice: (650) 210-0100 Fax: (650) 210-0101 support@ajubasolutions.com |