Previous: Windowing and binning CCD data
Up: Data acquisition with the CCD
Next: Multiple sequential exposures
Previous Page: Windowing and binning CCD data
Next Page: Multiple sequential exposures
If you need to pause and then restart a CCD exposure, do so using the following commands:
ICL> PAUSE UES ICL> CONTINUE UES
You can change the exposure time of a run in progress by issuing the following command:
ICL> NEWTIME UES <time in secs>
If you need either to abort a CCD exposure or stop it before the pre-set exposure time has elapsed, you can either set a new exposure time as above or use the following commands:
ICL> ABORT UES ICL> FINISH UESRemember that the ABORT command throws the data away!