Previous: CS100_ZOFF
Up: Reference section
Next: ETALON
Previous Page: CS100_ZOFF
Next Page: ETALON
Select the etalon to be servoed
Format: ETALON_VOLTAGE <parameter>
Units: none
Range: <parameter> = 1, 2, 4 or 6
Examples : ETALON_VOLTAGE 1
Comments: This command selects which etalon is to be servoed by the CS100. The signals between the etalon and CS100 are routed via a switch--box mounted on the side of TAURUS. Make sure the switchbox is switched on before issuing this command.