Previous: CS100_YOFF
Up: Reference section
Next: ETALON_VOLTAGE
Previous Page: CS100_YOFF
Next Page: ETALON_VOLTAGE
Applies an offset to the Z channel of the CS100 servo--loop
Format: CS100_ZOFF <offset>
Units: none
Range: --2048 < <offset> < 2047
Defaults: Defaults to 0 on power--up
Examples : CS100_ZOFF 100
Comments: Issuing CS100_ZOFF will only result in a change of state of the CS100 once external control has been enabled (command CS100_EXT). The etalon will only change state if the CS100 has been switched to the etalon (command ETALON_VOLTAGE) and the servo loop closed (command CS100_CLOSE).