Previous: CS100_XOFF
Up: Reference section
Next: CS100_ZOFF
Previous Page: CS100_XOFF
Next Page: CS100_ZOFF

CS100_YOFF

Applies an offset to the Y channel of the CS100 servo--loop

Format: CS100_YOFF <offset>

Units: none

Range: --2048 < <offset> < 2047

Defaults: Defaults to 0 on power--up

Examples : CS100_YOFF 100

Comments: Issuing CS100_YOFF will only result in a change of state of the CS100 once external control has been enabled (command CS100_EXT). The etalon will only change state if the CS100 has been switched to the etalon (command ETALON_VOLTAGE) and the servo loop closed (command CS100_CLOSE).


Thu Apr 7 00:29:52 BST 1994