Sets the readout speed to TURBO.
2=to: 2!:}Format: TURBO SPEED
2=to: 2!:}Comments: This is the second fastest of the CCD readout speeds. If you wish to run the CCD in this mode you must issue this command after every hard or soft reset of the CCD controller. This command is only available from the VHT vocabulary, if it appears not to work type VHT then try again. This instruction can also be issued over the network from the DMS terminal, to do this type >CCDn, where n denotes the network address of the CCD in question; then type TURBO.