Previous: SEX
Up: CCD controller commands
Next: T--STAT
Previous Page: SEX
Next Page: T--STAT
Previous: SEX
Up: CCD controller commands
Next: T--STAT
Previous Page: SEX
Next Page: T--STAT
Changes the readout rate to the slower (and lower noise) of the two allowed values.
Format: STANDARD SPEED
Comments: This resets the readout speed of the CCD back to the default (slower) speed, with reduced readout noise. This command is only available from the VHT vocabulary, if it appears not to work type VHT then try again. This instruction can also be issued over the network from the DMS terminal, to do this type >CCDn, where n is 1, 2, 3 or 4 and denotes the network address of the CCD in question; then type SLOUCH.