Previous: Direct control of the Cassegrain Instruments
Up: Engineering terminals
Previous Page: Direct control of the Cassegrain Instruments
Next Page: SETUP AND OBSERVING PROCEDURES

The Detector engineering control terminal

The Detector engineering control terminal can be used to communicate with one of the CCD controllers, including the autoguider CCD controllers. A limited number of CCD commands, used for assessing the performance of the CCDs and for taking test exposures when the Vax 4000 system computer is not available, are available to users and are documented in Section 12.3 of this manual.


Fri Jan 7 15:34:48 GMT 1994