Previous: LIST
Up: Listing
Previous Page: LIST
Next Page: Using the Mailserver

SHOW

The SHOW command may be used to get information about values, units or codes used by ARCQUERY. Information can be shown about: Address_info, Code_groups, Defaults, Requests, Symbols, Tables, Units, and Users. Some examples:

• SHOW UNITS , or SHOW UNITS=group

  will show all units supported, or all units of a particular group ( e.g. distance, angle, etc. ).

• SHOW CODE_GROUP = WAVEBAND

  will produce a list of waveband filter names known to the archive.

• SHOW CODE = OBJ_TYPE

  lists the object-type codes (section ) used by ARCQUERY.

• SHOW USER=EJZ

  will produce details about archive user EJZ.

For further details, see section .