Previous: CH(IP) - Sets new chip parameters
Up: STARTING AND FINISHING
Previous Page: CH(IP) - Sets new chip parameters
Next Page: CCD CONTROL COMMANDS

SHUTDOWN - Shut down the system

The filter and CCD software and then the ADAM system itself are closed down.

Parameters

None

Examples

Adam:> SHUTDOWN - then answer question about log file.

SIGNOFF

Notes

This does not work in Option 3 (Adam without instrument) but QUIT does.

If SHUTDOWN fails and leaves you in ADAM type:

GET BASICDEF;QUIT

(This is two commands, the semi-colon being used as a separator)