Previous: TEL(E) - system telemetry
Up: CCD Control commands
Next: QFL(ASH)/SETFLA(SH)/FL(ASH) - pre-flash control
Previous Page: TEL(E) - system telemetry
Next Page: QFL(ASH)/SETFLA(SH)/FL(ASH) - pre-flash control
CLEAR clears the chip, NOCLEAR suppresses CLEAR on the next GLANCE or RUN, EXPOSE t exposes for t seconds and READ reads out the chip to the GLANCE file.
ParametersOnly EXPOSE needs a parameter. It is mandatory and is the exposure time in seconds.
READ will assume the GLANCE file, but if a parameter is specified, it will be taken as the file into which to read.
Examples
Adam:> CLEAR clear the chip Adam:> NOCLEAR Don't clear the chip on the next GLANCE or RUN Adam:> EXPOSE 10 expose for 10 seconds Adam:> READ read out the chip
Notes
If t=0, EXPOSE does precisely nothing.