Previous: PA(USE)/CONT(INUE)/STO(P)/ABO(RT) - run control (1)
Up: CCD Control commands
Next: RUNSTAT(US)/TIM(E) - run control (2)
Previous Page: PA(USE)/CONT(INUE)/STO(P)/ABO(RT) - run control (1)
Next Page: RUNSTAT(US)/TIM(E) - run control (2)
This command will be needed only under one very specific circumstance: a CCD exposure is running and ADAM crashes for any reason, e.g. power failure.
Parameters
None
Notes
On RESTARTing ADAM the run active bit may still be set in the CCD controller. If this is the case, the software detects the fact and asks you to type RESTART when the ADAM:> prompt appears. Only after RESTARTing are you able to do further RUNs or GLANCEs.