Previous: RSPEED
Up: Commmand descriptions
Next: SCRATCH
Previous Page: RSPEED
Next Page: SCRATCH
Takes an exposure of an astronomical target, and transfers the data plus headers to a file on the system computer.
Format: RUN <channel> <time> [" Channel: The name of the data-acquisition channel to be used.
Time: The exposure time in seconds
Title: A title for the observation.
Examples: RUN RED 1.5 "NGC1068 nucleus"
Queuable: Yes.
Comments: This command takes a single exposure of an
astronomical target, collects header information
pertaining to that exposure, and transfers both data
and headers into a file on the system computer.
During the observation the system will report the
run number allocated, and will announce the start
and end of the exposure. Exposures cannot
be carried out until a format has been set up.