Previous: NOTE
Up: Commmand descriptions
Next: PAUSE
Previous Page: NOTE
Next Page: PAUSE
Previous: NOTE
Up: Commmand descriptions
Next: PAUSE
Previous Page: NOTE
Next Page: PAUSE
Resets the IPCS' camera-format to show as much of the intensifier as possible.
Format: OVERSCAN <channel>
Channel: The name of the data-acquisition channel.
Examples: overscan ues
Queuable: Yes.
Comments: Use this command to check for over-illumination when changing sources and whenever you open the IPCS shutter. The revised camera-format is temporary: it is not stored on disk and the system will forget it if restarted. Reformat after overscan will rstore the previous camera-format. Overscan does not change the resolution factors.