next up previous contents
Next: T-STAT Up: CCD controller commands Previous: SLOW SPEED


Changes the readout rate to STANDARD.

2=to: 2!:}Format: STANDARD SPEED

2=to: 2!:}Comments: This resets the readout speed of the CCD to the default speed. This command is only available from the VHT vocabulary, if it appears not to work type VHT then try again. This instruction can also be issued over the network from the DMS terminal, to do this type >CCDn, where n denotes the network address of the CCD in question; then type SLOUCH.

manuals store
Wed Sep 17 12:36:20 BST 1997