next up previous contents
Next: CLOSE Up: CCD controller commands Previous: 1V

2V

Commands after this refer to Virtual Head 2

2=to: 2!:}Format: 2V

2=to: 2!:}Comments: After issuing this command further CCD commands will affect Virtual Head 2, until this is changed by issuing 1V. Commands that require the correct Virtual Head to be set include: QUICK SPEED; STANDARD SPEED; CONFIG; RED; PIC; CLR and local binning and windowing commands. Consult RGO technical staff to find out which Virtual head number refers to the CCD you are using.



manuals store
Wed Sep 17 12:36:20 BST 1997