Previous: 1V
Up: CCD controller commands
Next: CLOSE
Previous Page: 1V
Next Page: CLOSE

2V

Commands after this refer to Virtual Head 2

Format: 2V

Comments: After issuing this command further CCD commands will affect Virtual Head 2, until this is changed by issuing 1V. Commands that require the correct Virtual Head to be set include: QUICK SPEED; STANDARD SPEED; CONFIG; RED; PIC; CLR and local binning and windowing commands. Consult RGO technical staff to find out which Virtual head number refers to the CCD you are using.


Fri Jan 7 15:34:48 GMT 1994