Previous: EXPOSE
Up: Data Taking Commands - IPCS detector
Next: IPCONT
Previous Page: EXPOSE
Next Page: IPCONT
Starts an exposure on a specified detector without collecting the archive packets.
Format: EXPOSENP <detectorname> <exposuretime>
Example: EXPOSENP IPCS 1000
Synonym: ENPI ( EXPOSE IPCS)
Units: Seconds.
Comments: This command works as expose, but does not collect archive packets. This saves time if you do no expect to KEEP the data. However if you run KEEP after EXPOSENP then KEEP will collect the archive packets.