Previous: OVERSCAN
Up: Data Taking Commands - IPCS detector
Previous Page: OVERSCAN
Next Page: Other DMS Commands
Previous: OVERSCAN
Up: Data Taking Commands - IPCS detector
Previous Page: OVERSCAN
Next Page: Other DMS Commands
Runs the IPCS EHT down slowly.
Format: STANDBY
Comments: This is equivalent to setting the rotary switch on the IPCS cubicle on the telescope to ``STANDBY'' and pressing the ``LOAD'' button. In either case it is important to verify that the IPCS EHT has in fact run down, by checking the EHT supply on the telescope or the raw video display, before switching any lights on in the dome.