Previous: Display list files: TYPE, PRINT and SPOOL (T, P, SP)
Up: Listing and showing information
Previous Page: Display list files: TYPE, PRINT and SPOOL (T, P, SP)
Next Page: Requesting data or action from archive operators

Show general information: SHOW (SH)

At any point in an ARCQUERY session the SHOW command may be used to obtain either specific or general information. The syntax of the command is:

SHOW[/qualifiers] [keyword[.ro.value-set][,....],

where the only relational operators allowed are ` =' and ` <>'.

The following rules apply: If keyword is specified as *, all values are shown; if keyword is specified without relation or value, a default will be used; and if the command is used without keywords, just: SHOW , the keywords DEFAULTS and TABLES will be shown.

Information is available about:


Fri Aug 12 10:24:53 BST 1994