Previous: Comments
Up: Using the Mailserver
Previous Page: Comments
Next Page: The ARCQUERY command language

Returned Output

Listings and other output generated by a server session will be returned to you via E-mail. The address ARCQUERY uses is either your address from the user data base, if it exists, or any E-mail address you may specify during the current server session. If no address is known, the server will use a return address for mail output, which it derives by retracing your original server message.

Note that you can get table listings in two different ways: the first one is by doing a select (nolist!), followed by a list, as mentioned above. The second way is to do a SELECT/FILE/NOLIST/......, followed by PRINT and EXIT/MAIL/...... In the latter case you will receive the listing as a separate message, else you will get the listing as part of your server message.