Appendix C. Wiring Details for Dutch controller

 

 

 

Cryostat Temperature Connector

Amphenol 12-10 connector
 

A Heater +
B Heater -
C LED +
D LED -
E Temp Sense ground
F Temp sense
G Temp sense ref.
H Temp sense +10V

 

The heater is a 100 Ohm power resistor. The temperature sensor is built into a bridge arrangement inside the cryostat. Its resistance can be measured directly between pins E and F. It is a Pt100 sensor with a coefficient of -0.4046 Ohms per degree C. The internal LEDS have no current limiting resistors, a current of 5mA for about 1s will give a deep exposure.